Hi everyone,
I recently swapped out the factory turn signals and swapped the undertail as well. I tested each light as i made each connection since none of the aftermarket lights were”plug n play” and all the correct connections were made. But when I started the bike after everything was connected and the tail put back on, the front and rear turn signals, the hazards, license plate lights and the turn signal display are all not working. Any suggestions? The fuse isn’t blown.
I recently swapped out the factory turn signals and swapped the undertail as well. I tested each light as i made each connection since none of the aftermarket lights were”plug n play” and all the correct connections were made. But when I started the bike after everything was connected and the tail put back on, the front and rear turn signals, the hazards, license plate lights and the turn signal display are all not working. Any suggestions? The fuse isn’t blown.